Ignition Event/Investigation Cycle

This forum is for the open, public discussion of the Crash Data Retrieval Tool or Event Data Recorder technology. This is open to any registered user of the CrashForum.info site and not intended for direct CDR Tool User technical or analytical support.
Post Reply
User avatar
williamporter
Posts: 18
Joined: Fri Feb 26, 2016 7:20 am
First Name: William
Last Name: Porter
Location: Memphis, Tennessee

Ignition Event/Investigation Cycle

Post by williamporter »

I downloaded data from a EDR where the ignition cycle at the event is more than 300 cycle at the investigation. It shows the number of cycles the SIR lamp was on/off at over 300 cycles and 26 cycles since the DTC was cleared at event enable. Question: How can I prove that the data from the deployment event is from my event? This is the first time I had a 300+ cycle different.

User avatar
actar670
Posts: 182
Joined: Wed Feb 15, 2012 7:43 pm
First Name: Bruce
Last Name: McNally
Location: Rochester, New Hampshire
Contact:

Re: Ignition Event/Investigation Cycle

Post by actar670 »

There are a number of ways to determine if the data is related to the crash you're investigating, but much of it depends upon the type of data file you have. If you post the .cdrx file of the data we might be able to offer suggestions.
Bruce McNally
McNally & Associates ARS, LLC
41 Champlin Ridge Road
Rochester, NH 03867
Office (603) 516-4560
Web http://mcnallyassociates.com

Post Reply